1. DcCrap
2. Beetle Connection manager
3. config file
4. Common SENSE
Steps:
1. Plug in your SmartBRO MODEM
2. Open QPST
3. Go to “device manager” and find the port of your SmartBRO MODEM (click ‘start’, right click ‘computer’, select ‘properties’ and click ‘device manager’)
5. Select SmartBRO MODEM port and click ‘EFS Explorer’ then click “OK”
6. Delete “config” file and replace the new config from attachement
7. Now! Close EFS explorer, Close QPST
8. Download ZTE beetle connection manager from 4shared (note: need register to download)
9. If download finish go to downloaded folder and rename beetle connection manager to ZTEMODEM (note: caps lock ON, don't change file extension *.ISO)
10. After renaming open dccrap (note: run as administrator on win7 or vista)
11. On manufacturer select “ZTE Datacards”
12. On model selection select “auto detect”
13. Then click a “magnifying glass”
14. Oh ito! kung ganyan yung nangyari pwede nyo na i-cancel (click hand with red backround) pero detected na po iyan
15. Click Flash then click Write Dashboard then select your downloaded beetle connection manager (note: dapat ZTEMODEM ang name nya
)16. Wait Until 100% writing
17. After writing close dccrap , plug out your SmartBRO uninstall old dashboard, delete all registry with ccleaner and restart your PC
18. After restarting plug in your Smart BRO don't worry auto install beetle connection manager and wait install drivers DONE!
here my screenshot
connection manager (check)
call feature (check)
message feature (check) (syempre)
phone book feature (check) (yummy)
signal (check)
naging 2G or edge ba ang signal? syempre hindi mas mabilis pa ito kaysa sa dating dashboard
ang maganda pa dito sa dashboard na ito hindi nyo na kailangan mag set ng APN automatic na yan
thats all!
good luck!
important:
kung gusto nyo ito pero baka masira modem mo tignan nyo muna kung ZTEMODEM.iso ang pangalan ng MODEM nyo Using QPST, kung ZTEMODEM.iso nga BOOM! capable yan!
Post a Comment